Nortel Passport 7400, Hardware Installation, Maintenance, And Troubleshooting, Page: 417 / 438

Chapter 37 Hardware procedures 417
Passport 7400 Hardware Installation, Maintenance, and Upgrade 5.2S1
Unpacking a 5-slot Passport switch
Unpack a 5-slot Passport switch close to the installation site.
Procedure steps
1 Set the box on floor with top end down.
2 Cut tape sealing the bottom flaps.
3 Fold back the bottom flaps against the outside sides of the box.
4 Turn the box right side up as you hold the bottom flaps out.
5 Lift the box up and off of the switch.
6 Remove the box that contains the power supply.
7 Remove the packing material.
8 Compare the contents of your shipment with the table “Equipment
checklist for unpacking a 5-slot Passport switch” (page 417)and the figure
“Taking inventory after unpacking a 5-slot Passport switch” (page 419) to
ensure you have all the hardware components you require.
Table 11
Equipment checklist for unpacking a 5-slot Passport switch
Equipment
Switch with pre-installed:
• Function processors (1 to 4 for each switch)
• Blank processor cards (4 for each switch less the number
of function processors)
• Fan tray and filter assembly
Power supply and a blank power supply
Ac power cords (1 for each power supply)
or
Dc power wiring. See 241-7401-200 Passport 7400
Hardware Description for dc power cabling requirements.
Control processor (1 or 2)
Function processor cables
(Sheet 1 of 2)