Nortel Passport 4430, Hardware Installation, Page: 17 / 176

2-1
Installing the Passport 4400
2
This chapter describes the procedures used to set up and connect a Passport
4400 unit (Passport 4430/4450/4455).
Refer to the following manuals for relative information:
• Using Passport 4400 Install Tool Version 4.0 (800-1983-40)
• Configuring and Operating Passport 4400 (800-2002-40) on-line
documentation
This chapter will take you through the following installation procedures:
• Preparing the Site on page 2-1
• Unpacking Your Passport 4400 Unit on page 2-3
• Passport 4400 Rackmount Kit on page 2-3
• Passport 4400 Rack Installation on page 2-4
• Connecting an AC Unit on page 2-5
• Connecting a DC Unit on page 2-7
Preparing the Site
Before connecting the Passport 4400 unit, select a location that conforms to the
following environmental requirements:
•
Sp
ace requirements (Figure 2-1, Figure 2-2, or Figure 2-3)
• Surrounding temperature (page 2-3)
• Distance to the AC socket (if unit is AC-powered) – the supplied power
cord is 18.29m (6 feet) long
Note: For information about installing the Passport 4400 unit in a
rack, refer to page 2-4.