Nortel Passport 15000, Hardware Installation And Maintenance, Page: 402 / 874

402 Chapter 17 Hardware procedures
241-1501-240 5.2S2
Installing a cosmetic extension filler
Install a cosmetic extension filler onto the lower left and right of the base of
a NEBS 2000 frame at its front or rear (or both) as part of enclosing a frame.
Prerequisites
• You must be familiar with “Safety considerations and best practices”
(page 53).
• You need 2 cosmetic extension fillers from kit NTRU0192 as shown in
the figure “A cosmetic extension filler P0884951” (page 403) and a
bracket as shown in the figure “A lower right extension bracket
P0995493” (page 404) and its left version P0995494. A filler is the same
shape and orientation for either the left or right side of the frame.
• For two cosmetic fillers, you need 4 Pozidriv screws P0600060, 12
P0600061, and 16 lock washers P0600895 from kit NTPX4060 as shown
in the figure “Types of screws used with frame enclosure hardware”
(page 120).
Procedure steps
1 Loosely fasten 6 Pozidriv 16-mm screws P0600061 each with a lock
washer P0600895 through the lower right extension bracket P0995493
from inside the base of the frame as shown in the figure “Orientation of a
cosmetic filler, a lower door catch, and a lower right extension bracket”
(page 405). Drive the screws from the inside of the frame base to the
outside.
2 Align the holes of the filler with the holes on the outside of the lower right
extension bracket as shown in the figure “Orientation of a cosmetic filler,
a lower door catch, and a lower right extension bracket” (page 405).
3 Loosely fasten the filler to the extension bracket with 2 Pozidriv 12-mm
screws P0600060 each with a lock washer P0600895. Drive the screws
from the direction shown in the figure.
4 Tighten all screws to snug plus a 1/4 turn.
5 Repeat step 1 to step 4 for the lower left side using the figure “Orientation
of a cosmetic filler, a lower door hinge, and a lower left extension bracket”
(page 406).