Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 92 / 368

Using CallPilot Manager to monitor hardware Standard 1.0
92 CallPilot
Maintenance activities for each component
The following table identifies the maintenance activities you can perform
for each component that is listed in the component tree:
Maintenance This section shows the state of the selected component. Use
this section to start and stop a component before running a
diagnostic test.
This section appears only for components on which you are
allowed to perform maintenance administration.
For more information about working with component
states, see the following sections:
“Viewing component states” on page 94
“Starting and stopping components” on page 97
Diagnostics Use the Diagnostics section to run one or more diagnostic
tests, or to view the results of the last diagnostic tests that
were run on the selected component.
This section appears only for components on which you are
allowed to run diagnostics.
For more information about running diagnostics, see the
following sections:
“Running integrated diagnostics” on page 101
“Viewing the last diagnostic results” on page 106
Component
Start, stop, or
courtesy stop? Diagnostics
available?
Replaceable?
Media Bus Yes Yes No
MPB board Yes Yes Yes
Section Description