Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 166 / 368

Replacing a hard drive, tape drive, CD-ROM drive, or floppy drive Standard 1.0
166 CallPilot
To configure the tape drive
Note: Some settings may already be properly configured. If it is not clear
from the drive manufacturer’s documentation how to set jumpers, contact
your Nortel Networks technical support representative.
1 Set the SCSI ID to 6.
2 Disable the Active Terminators (Term Enable).
Note: Termination is provided by an Active SCSI terminator that you
connect to the end of the SCSI cable (see “Cabling example” on page
165).
3 Enable Parity Checking.
4 Enable Termination power (TPWR).
5 Leave the remaining settings at the default values.
To install a new tape drive (no tape drive previously installed)
1 Courtesy down CallPilot and then power down the server.
2 Ensure that the tape drive settings are as described in “To configure the
tape drive” on page 166 .
3 Remove the chassis cover.
4 Remove the media drive carrier (see “Removing the media drive carrier
from the chassis” on page 157).
5 Slide the new tape drive into the media drive carrier, and secure it with
four undercut Phillips-head screws.
Note: You may need to first remove other media drives from the carrier to
access the tape drive slot.
6 Reattach any media drives that you removed in order to access the tape
drive slot.
7 Position the media drive carrier in the media drive bay, leaving enough
room to reach behind the carrier, and attach the connectors.
8 Carefully connect the existing signal and power cables as shown in
“Cabling example” on page 165.