Nortel business policy switch 2000, User Manual

Page: 309 / 412

309
Using the Business Policy Switch 2000 Version 2.0
Chapter 5
Sample QoS configuration
You can configure QoS using the Common Open Policy Services (COPS), the
CLI, the Web-based management system, SNMP, or Device Manager. This section
presents a sample QoS configuration using the Web-based management system
using the QoS Advanced pages.
For more information on configuring QoS with the Web-based management
system, refer to
Using Web-based Management for the Business Policy Switch
2000 Software Version 2.0 . For information on configuring QoS with other
management systems, refer to Reference for the Business Policy Switch 2000
Command Line Interface Software Version 2.0 and Reference for the Business
Policy Switch 2000 Command Line Interface Software Version 2.0 .
You can configure QoS using the embedded Web-based QoS Wizard in the. The
QoS Wizard allows you to configure simplified policies and common filters to
control the behavior of network traffic in your standalone or stack switch
configuration. In addition, you can prioritize a VLAN to receive better service
than others.
Warning:
Nortel Networks recommends that you use the QoS Wizard
for your initial configuration only. Each time the QoS Wizard is initiated,
all existing configurations are reset to the default values. After you
complete the
initial QoS Wizard configuration method, you can then
customize traffic treatment using the QoS Quick Config or QoS
Advanced configuration process.