Nortel business policy switch 2000, User Manual

Page: 247 / 412

Chapter 3 Using the console interface 247
Using the Business Policy Switch 2000 Version 2.0
Table 43 describes the Renumber Stack Units screen options.
Hardware Unit Information screen
The Hardware Unit Information screen ( Figure 89 ) lists the switch models,
including any installed MDA and Cascade modules, that are configured in your
standalone or stack configuration. In addition, this screen displays the software
version running on the hardware.
To open the Hardware Unit Information screen:
➨
Choose Display Hardware Units (or press h) from the main menu.
Table 43 Renumber Stack Units screen options
Option Description
Current Unit Number Read-only fields listing the current unit number of each of the configured stack
units. The entries in this column are displayed in order of their current physical
cabling with respect to the base unit, and can show nonconsecutive unit numbering
if one or more units were previously moved or modified. The entries can also
include unit numbers of units that are no longer participating in the stack (not
currently active).
MAC Address Read-only field listing the MAC address of the corresponding unit listed in the
Current Unit Number field.
New Unit Number User-settable field showing the current unit number of each unit in the stack. You
can change any of the fields, as required. You can also delete entries by typing
zero (0) or using the space bar to clear the field.
Default Value Current stack order
Range 1 to 8
Renumber units with
new setting? Specifies whether to start the renumbering process (default is No). Use the
spacebar to toggle the selection to Yes.
Renumbering resets the switch with the current configuration values. When you
select this option, the switch resets, runs a self-test, then displays the Nortel
Networks logo screen. After you press [Ctrl]-Y at the screen prompt, the console
screen temporarily displays the (standalone) Business Policy Switch main menu.
Then, within 20 seconds, the console screen refreshes and displays the main
menu screen for the stack configuration. The Unit LEDs display the new numbering
order.
Default Value No
Range No, Yes