10
Figure 3 Inserting a
CWDM GBIC
into the switching module
Removing a CWDM GBIC
Use the following procedure to remove a CWDM GBIC. When
storing a CWDM GBIC, place a dust cover over the fiber optic
bores
.
To remove a CWDM GBIC from the switching module:
1
Disconnect the fiber cable from the CWDM GBIC connector.
2
Grasp the extraction tabs (
Figure 1
) located on either side of
the CWDM GBIC between your thumb and forefinger.
3
Slide the CWDM GBIC out of the Gigabit Ethernet module
slot.
4
If the CWDM GBIC does not slide easily from the module
slot, use a gentle side-to-side rocking motion while firmly
pulling the CWDM GBIC from the slot.
Note:
When disposing of a CWDM GBIC, comply with
all national laws and regulations
.
9708FA
