Nortel 703t, Maintenance And Diagnostics, Page: 168 / 248

Replacing media drives Standard 1.06
168 CallPilot
4 Place the drive label-side up inside the carrier, and then attach the
drive to the carrier with the four screws you removed earlier. See
Figure 29.
Figure 29: Attach disk drive to carrier
Ensure that the carrier is aligned with the two screw holes closest to
the front of the floppy disk drive. Tighten the screws firmly.
5 Install the drive carrier inside the server.
Slide the assembly toward the front of the system, and engage it
with the bracket tabs on the side of the drive bay.
Note: The bottom of the drive/bracket assembly must accept the
tab that sticks out from the inside of the front panel. Ensure that the
front of the drive fits flush in the front opening of the system. (See
the “Floppy disk drive installation overview” on page 165.)
6 Secure the assembly to the server’s front panel with the screws you
removed earlier. Tighten the screws firmly.
G101774