General Switch Administration using the Web-based Management Interface
203
Section
Item
Range
Description
In-Band
Subnet
Mast
XXX.XXX.XXX.XXX
Type a new subnet mask in the
appropriate format.
Gateway
Setting
Default
Gateway
XXX.XXX.XXX.XXX
Type an IP address for the default
gateway in the appropriate format.
Note: If you assign an IP address to the device and the BootP
process times out, the BootP mode remains the default mode
of BootP when needed.
However, if you do not assign an IP address to the device and
the BootP process times out, the BootP mode automatically
changes to BootP disabled. But this change to BootP disabled is
not stored, and the BootP reverts to the default value of BootP
when needed after you reboot the device.
2
In the fields provided, enter the IP configuration information.
3
Click Submit.
—End—
Modifying system settings
The you can configure or change the system name, system location, and
network manager contact information.
Note: The configurable parameters on the System screen are displayed
in a read only-format on the Web-based Management Interface System
Information home page.
To configure system settings, perform the following procedure:
Step
Action
1
To open the System screen, select Configuration > System, as
illustrated in
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.