174
Switch administration tasks
"show ip parameters" (page 174)
describes the parameters and variables
for the
show ip
command.
show ip parameters
Parameters and
variables
Description
bootp
BootP-related IP information.
default-gateway
The IP address of the default gateway.
address
The current IP address.
Assigning and clearing IP addresses for specific units
You can use the CLI to assign and clear IP addresses for a specific unit in
a stack. For details, see the following sections:
•
"ip address unit command" (page 174)
•
"no ip address unit command" (page 174)
•
"default ip address command" (page 175)
ip address unit command
The
ip address unit
command sets the IP address and subnet mask of
a specific unit in the stack.
The syntax for the
ip address unit
command is
ip address unit <1-8> [A.B.C.D]
Run the
ip address unit
command in Global Configuration command
mode.
"ip address unit parameters" (page 174)
describes the parameters this
command.
ip address unit parameters
Parameters and
variables
Description
unit <1—8>
Sets the unit you are assigning an IP address.
A.B.C.D
Enter IP address in dotted-decimal notation.
Note: When the IP address or subnet mask changes, connectivity to
Telnet and the Internet can be lost.
no ip address unit command
The
no ip address unit
command sets the IP address for the specified
unit in a stack to zeros (0).
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.
