160
Power over Ethernet
"poe-limit parameters" (page 160)
outlines the parameters for this command.
poe-limit parameters
Parameter
Description
port <portlist>
The ports to set the limit on
<3 - 16>
The power range to limit at from 3 to 16 W
Run the
poe-limit
command in Interface Configuration command mode.
Set traps control
The
poe-trap
command enables PoE-related traps for PoE-enabled ports.
The syntax for the
poe-trap
command is
poe poe-trap [unit <1-8>]
Substitute
<1-8>
with the number of the unit on which to enable traps.
Show main power status
The
show poe-main-configuration
command displays the power
configuration.
The syntax for the
show poe-main-configuration
command is
show poe-main-status [unit
<1-8>]
Substitute
<1-8>
with the number of the unit for which to display the
configuration.
Run the
show poe-main-status
command in Privileged EXEC
command mode.
Set power usage threshold
The
poe-power-usage-threshold
command sets the power usage
threshold in percentage on individual units.
The syntax for the
poe-power-usage-threshold
command is
poe poe-power-usage-threshold [unit <1-8>] <1-99>
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.
