Configuring PoE using the CLI
159
Set port power enable or disable
Use the
poe-shutdown command
to disable PoE to a port.
The syntax for the poe-shutdown command is
poe poe-shutdown [port <portlist>]
Use the
no poe-shutdown
command to enable PoE to a port.
The syntax for the
no poe-shutdown
command is
no poe-shutdown [port <portlist>]
In either command, substitute
<portlist>
with the ports on which PoE is
enabled or disabled.
Run the
poe-shutdown
and
no poe-shutdown
commands in Interface
Configuration command mode.
Set port power priority
The
poe-priority
command sets the port power priority.
The syntax for the
poe-priority
command is
poe poe-priority [port
<portlist>] {critical | high | low}
"poe-priority parameters" (page 159)
outlines the parameters for this
command.
poe-priority parameters
Parameter
Description
port <portlist>
The ports to set priority for
{low | high | critical}
The PoE priority for the port
Run the
poe-priority
command in Interface Configuration command
mode.
Set power limit for channels
The
poe-limit
command sets the power limit for channels.
The syntax for the
poe-limit
command is
poe poe-limit [port <portlist>] <3-16>
Nortel Ethernet Routing Switch 4500 Series
Overview — System Configuration
NN47205-500
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.
