Nortel 425-24T, Configuration Manual, Page: 275 / 488

Chapter 7 System configuration using the CLI 275
System Configuration Guide
The
boot
command is in the privExec command mode.
Table 75 describes the parameters and variables for the
boot
command.
ip bootp server command
The
ip bootp server
command configures BootP on the current instance of
the switch or server. The syntax for the
ip bootp server
command is:
ip bootp server {last|needed|disable|always}
The
ip bootp server
command is in the config command mode.
Table 76 describes the parameters and variables for the
ip bootp server
command.
Table 75 boot command parameters and variables
Parameters and
variables
Description
default Restores switch or stack to factory-default settings after rebooting.
Note: When you reset to factory defaults, the stack operational mode,
last reset count, and reason for last reset will not be set to factory
defaults.
Table 76 ip bootp server command parameters and variables
Parameters and
variables
Description
last|needed|disable|
always Specifies when to use BootP:
• last—use BootP or the last known address
• needed—use BootP only when needed
• disable—never use BootP
• always—Always use BootP