Nortel 425-24T, Configuration Manual, Page: 253 / 488

Chapter 7 System configuration using the CLI 253
System Configuration Guide
Table 58 describes the parameters and variables for the
ip address
command.
no ip address command
The
no ip address
command clears the IP address and subnet mask. This
command sets the IP address and subnet mask for a switch or a stack to all zeros
(0). The syntax for the
no ip address
command is:
no ip address {stack|switch}
The
no ip address
command is in the config command mode.
Table 59 describes the parameters and variables for the
no ip address
command.
Table 58 ip address command parameters and variables
Parameters and
variables
Description
stack|switch Sets the stack the IP address and subnet mask or the switch IP
address and netmask.
unit Sets the IP address of another unit in a stack.
XXX.XXX.XXX.XXX Enter IP address in dotted decimal notation; netmask is optional.
netmask Set the IP subnet mask for the stack or switch.
Note: When you change the IP address or subnet mask, you may lose
connection to Telnet and the Web.
Table 59 no ip address command parameters and variables
Parameters and
variables
Description
stack|switch Zeroes out the stack IP address and subnet mask for the switch IP
address and subnet mask.
unit Sets the IP address of another unit in a stack.