Nortel 425-24T, Configuration Manual, Page: 122 / 488

122 Chapter 3 CLI Basics
320985-A Rev 01
Table 20 describes the command mode prompts and entrance/exit commands.
The prompt displays the switch name, and the current CLI command mode. For
example:
• User EXEC—
425-48T>
• Privileged EXEC—
425-48T#
• Global Configuration—
425-48T(config)#
• Interface Configuration—
425-48T(config-if)#
Refer to Appendix E, “Command List,” on page 447 , for a complete, alphabetical
list of all CLI commands and where they are explained.
Table 20 Command mode prompts and entrance/exit commands
Command
mode Prompt for the Ethernet
Switch 325 Prompt for the Ethernet
Switch 425
Enter/exit command
User EXEC
(exec)
325-24T> 425-48T>
Default mode,
automatically enter
logout or exit to
quit to Main Menu
Privileged EXEC
(privExec)
325-24T# 425-48T#
enable to enter from
User EXEC mode
logout or exit to
quit to Main Menu
Global
Configuration
(config)
325-24T(config)# 425-48T(config)#
configure to enter
from Privileged EXEC
mode
end or exit to exit to
Privileged EXEC mode;
logout to quit to Main
Menu
Interface
Configuration
(config-if)
325-24T(config-if)# 425-48T(config-if)# interface
FastEthernet
{<portnum>|all}
to
enter from Global
Configuration mode
logout to quit to Main
Menu; end to exit to
Privileged EXEC mode;
exit to exit to Global
Configuration mode