Nortel 1000E PRI, Installation And Commissioning Manual

Page: 127 / 162

Maintain downloadable D-channels 127
Command Description
RCNT loop Reset alarm counter of DTI/PRI loop.
RMST loop Perform self-test on loop.
RMST l ch Perform self-test on specified channel (2.0 Mb/s DTI/PRI only.)
--End--
To maintain the clock controller, follow Procedure 49 “Maintaining the clock
controller using LD 60” (page 127) .
Procedure 49
Maintaining the clock controller using LD 60
Step Action
1 Log on to the CS 1000E.
2 To access LD 60, enter:
LD 60
3 Enter the commands as shown in Table 36 "Clock controller
maintenance (LD 60)" (page 127) .
Table 36
Clock controller maintenance (LD 60)
Command Description
DIS CC l s Disable system clock controller on specified superloop and shelf.
ENL CC l s Enable system clock controller on specified superloop and shelf.
SSCK l s Get status of system clock on specified superloop and shelf
TRCK aaa l s Configure clock controller on IPMG specified by the superloop and shelf
tracking to primary, secondary or free run, where aaa is:
PCK = track primary clock
SCLK = track secondary clock
FRUN = free run mode
--End--
Maintain downloadable D-channels
D-channel commands for the DDCH/MSDL are supported for the E1/T1
card. See
Procedure 50 “Maintaining the DDCH using LD 96” (page 127) .
Procedure 50
Maintaining the DDCH using LD 96
Nortel Communication Server 1000
Media Gateway 1000E PRI Gateway Installation and Commissioning
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
.