4
VENTING SYSTEM
WARNING:
It is imperative to maintain proper operation of the
venting system, including the masonry chimney
(if applicable). Insufficient venting could create
the production of excessive amounts of Carbon
Monoxide (CO) - a colorless, odorless gas that is
produced during incomplete combustion of any
fuel. It can cause death without warning. Carbon
monoxide poisoning can cause flu- like symptoms
and also dizziness, fatigue, headaches, nausea,
and irregular breathing.
If you suspect that you are experiencing CO
poisoning, get fresh air immediately. Leave the
home and call for assistance from a neighbor’s
home.
WARNING:
CARBON-MONOXIDE POISONING HAZARD
Failure to follow instructions could result in severe
personal injury or death due to carbon-monoxide
poisoning if combustion products infiltrate into the
building.
Check that all openings in the outside wall around
the vent (and air intake) pipe(s) are sealed to prevent
infiltration of combustion products into the building.
Check that furnace vent (and air intake) terminal(s) are
not obstructed in any way during all seasons.
• The U.S. Consumer Product Safety Commission (CPSC)
recommends every home have a Carbon Monoxide detector
in hallways near the bedrooms in each sleeping area. CO
detectors should be certified to the most recent requirements
of the UL, IAS OR CSA Standard and should be installed,
operated, and maintained in accordance with the detector
manufacturers instructions.
SOURCES OF CORROSION
It is known that certain common household chemicals can
cause heat exchanger corrosion if the vapors are pulled into
the furnace’s burners The following is a list of chemicals that
should not be used or stored near the furnace.
Do not store these chemicals near the furnace:
• Permanent wave solutions
• Chlorinated waxes and cleaners
• Chlorine based swimming pool chemicals
• Water softening chemicals
• De-icing salts or chemicals
• Carbon tetrachloride
• Halogen type refrigerants
• Cleaning solvents (perchloroethylene)
• Printing inks, paint removers, varnishes, etc.
• Hydrochloric acid
• Cements and glues
• Antistatic fabric softeners
• Masonry acid washing materials
CAUTION:
This furnace requires unrestricted airflow for
combustion and ventilation. For proper and safe
operation, it is extremely important that the furnace
receives an unobstructed flow of clean, fresh air
to properly burn the fuel gas. If this flow of air is
restricted, the partially burned combustion gases
may create dangerous amounts of carbon monoxide
that can cause personal injury or death.
• Do not block or obstruct air openings on the furnace, air
openings or spacings around the furnace area or the room
or closet the furnace is in. Furniture and drapery should be
arranged so that the supply air registers and return grilles
are not obstructed.
• If your furnace obtains its air through a pipe to the outdoors,
do not allow the inlet of the pipe to become blocked. If the
furnace is operated without adequate air for combustion, it
may cause unit safety devices to activate. This indicates
that a serious problem with the unit has occurred and must
be corrected immediately.
• Before remodeling near the furnace, consult with a local
code official or the National Fuel Gas Code to make sure
you will be in compliance with supplying adequate air for
combustion. By erecting new walls, it is sometimes possible
to inadvertently restrict the furnace’s air supply. You can
find more information about supplying combustion air in
the NFGC, which is available at many libraries.
CLEARANCES TO COMBUSTIBLES
WARNING:
Do not place combustible materials on or against
the furnace cabinet or within 6 inches of the vent
pipe. Furnace area must be kept clear and free
of combustible materials, gasoline and other
flammable vapors and liquids. A fire or explosion
may result causing property damage, personal
injury or loss of life. Failure to follow the safety
warnings exactly could result in serious injury,
death or property damage.
The furnace is designed to have certain clearances to
combustible items such as wood, paper, etc. Some types
of insulation are combustible. If your furnace is installed in
an attic, near unfinished walls, or in other insulated space,
keep area surrounding the furnace free of insulating material.
IMPORTANT SAFETY INFORMATION
