background image

4

Copyright © 2015 Nortek Security & Control LLC 

10008665 X2

SPECIFICATIONS

Power:

 

Two (2) CR2032 Lithium Coin Cell Batteries

Signal (Frequency):

  908.4 MHz / 916 MHz

Maximum Load: 

 None

Range:

 

Up to 130 feet line of sight

Z-Wave® and Z-Wave Plus® are registered trademarks of Sigma Designs

and its subsidiaries in the United States and other countries.

REGULATORY INFORMATION

The WA00Z-1 is certifi ed to comply with applicable FCC and IC rules and regulations governing RF and EMI emissions. 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device 
may not cause harmful interference, and (2) This device must accept any interference received, including interference 
that may cause undesired operation.

FCC Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance 
with the instructions may cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver
•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•  Consult the dealer or an experienced radio/TV technician to help.
•  Changes or modifications not expressly approved by the party responsible for compliance could void the user’s 

authority to operate the equipment

IC Notice

This Class B digital apparatus complies with Canadian ICES-003

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Le présent appareil est conforme 
aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux 
conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout 
brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

This device complies with the Industry Canada license exempt RSS standard(s). Operation is subject to the following 
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including 
interference that may cause undesired operation of the device.

WARRANTY

This Nortek Security & Control product is warranted against defects in material and workmanship for twelve (12) 
months. 

This warranty extends only to wholesale customers

 who buy direct from Nortek Security & Control or 

through Nortek Security & Control’s normal distribution channels. 

Nortek Security & Control does not warrant 

this product to consumers.

 Consumers should inquire from their selling dealer as to the nature of the dealer’s 

warranty, if any. 

There are no obligations or liabilities on the part of Nortek Security & Control for consequential 

damages arising out of or in connection with use or performance of this product or other indirect damages 
with respect to loss of property, revenue, or profi t, or cost of removal, installation, or re-installation.

 All implied 

warranties, including implied warranties for merchantability and implied warranties for fi tness, are valid only until 
Warranty Expiration Date as labeled on the product. 

This Nortek Security & Control LLC Warranty is in lieu of all 

other warranties express or implied. 

All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Nortek 
Security & Control Returns at 1-855-546-3279 for an RPA# and other important details.

IMPORTANT !!!

Radio controls provide a reliable communications link and fi ll an important need in portable wireless signaling. 
However, there are some limitations which must be observed.

•  For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15 devices. 

As such, they have limited transmitter power and therefore limited range.

•  A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals that 

occur on or near their operating frequencies, regardless of code settings.

•  Changes or modifications to the device may void FCC compliance.
•  Infrequently used radio links should be tested regularly to protect against undetected interference or fault.
•  A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, 

and these facts should be communicated to the ultimate users. 

Summary of Contents for GoControl WA00Z-1

Page 1: ...nd the network that a manually reset device is no longer in the network thus the corresponding Association becomes invalid INSTALLATION The WA00Z 1 can be installed anywhere adding a switch where it is most convenient The WA00Z 1 can be installed without any screws by using the included double sided tape In some cases mounting screws can be used to secure the WA00Z 1 over an existing wall switch A...

Page 2: ...er operating instructions to add this switch under the command of the Wireless Controller 1 With your Controller in Discovery or Add Mode press either button on the WA00Z 1 The green LED should flash twice 2 You should see an indication on your Controller that the device was added to the network 3 The device will appear in the list of Switches It should display as a switch NOTE If the Controller G...

Page 3: ...oup 2 will dim down Press the bottom button twice while holding down the button in 2nd press Z Wave devices in Association Group 3 will dim down NOTE You can set the Z Wave devices into Association Group 2 or Association Group 3 Maximum of five Z Wave devices can be added in each group CONFIGURATION The WA00Z 1 supports the Configuration command The WA00Z 1 can be configured to operate slightly di...

Page 4: ...ppareil doit accepter tout brouillage radioélectrique subi même si le brouillage est susceptible d en compromettre le fonctionnement This device complies with the Industry Canada license exempt RSS standard s Operation is subject to the following two conditions 1 this device may not cause interference and 2 this device must accept any interference including interference that may cause undesired op...

Reviews: