12
TS571W Installation Instructions
TS571W Installation Instructions
13
●
Remove the operator from the gate post
and gate brackets.
●
Swing the gate to the open position.
●
With the gate fully open, install the
closed position stop plate on the gate
opposite the operator (hardware not
included).
●
Do not fully tighten hardware until after
the next step.
INSTALLING THE CLOSED POSITION STOP PLATE / PUSH-TO-OPEN
T
V
L
L
P
N
N
S
S
●
Secure the gate bracket with the
supplied hardware as shown.
●
Once the gate post and gate
brackets are installed, reattached
the operator arm.
●
Ensure the operator arm is
level, adjusting the post bracket
location if necessary.
●
Once level, ensure all hardware
is tight.
●
Remove excess bolt length with a
hacksaw.
H
1
1
2
PUSH-TO-OPEN OPERATOR MOUNTING
Step 10
Step 1
Step 2
Step 11
●
Swing the gate to the closed position,
and adjust the closed position stop plate
against the fence post.
●
Tighten the mounting hardware.
●
With the gate in the closed position,
reinstall the operator arm.
Your Property
Your Property
