8
TS571W Installation Instructions
TS571W Installation Instructions
9
PUSH-TO-OPEN OPERATOR MOUNTING
PUSH-TO-OPEN OPERATOR MOUNTING
G
V
T
O
L
G
11”
S
S
E
F
B
N
N
G
V
T
O
L
G
11”
S
S
E
F
B
N
N
Step 1
Step 2
●
Assemble the gate post bracket subassembly
as shown with the Push-to-Open pivot bracket
(FM148). Must be purchased separate.
●
Attach the gate post bracket subassembly and
gate bracket to the operator as shown.
Level
horiz
ontal
cross
mem
ber
Level o
pener
Gate in Closed Position
Gate Bracket
Post Bracket Assembly
Step 3
Step 4
●
With the gate in the CLOSED
position, use clamps to secure the
operator to the gate post and center
cross member of the gate.
●
Ensure that the operator is level.
●
With the operator arm temporarily
secured to the gate, check to
ensure there is at least 2 inches
of clearance between the operator
arm and gate. (See illustration in
Step 4 below).
20” MAX
CLEARANCE DIAGRAM
●
Disconnect the operator arm from the
gate bracket.
●
While supporting the operator, swing
the gate and operator to the OPEN
position.
●
Check for recommended clearances
and binding as shown.
●
Ensure that the necessary arm stroke
does not exceed 20 inches.
●
Make adjustments to the
mounting brackets to achieve the
recommended clearances.
TIP:
Turning the pivot bracket over
gives more hole alignment options for
the gate post pivot bracket assembly.
Your Property
Your Property
Push-to-Open pivot
bracket (FM148)
