- 6 -
BLADE ADJUSTMENT
FIGURE 8
FIGURE 9
WARNING
VERY SHARP BLADE
1. Unscrew and remove the adjustment
plate screws (Fig. 8).
2. Tighten both adjustment plates by
1 or 2 holes (Fig. 9).
NOTE: The pitch on each lifting screw
is .125mm. The adjustment on both plates
must be the same.
ATTENTION! NO ADJUSTMENT IS NEEDED
ON ALL BRAND NEW UNITS.
Your tool cuts a wide variety of products.
Please refer to this cut guide for
recommended products and thicknesses.
• Fiber Cement Siding ..................9.5mm
• Laminate & Vinyl Flooring ...........15mm
• Engineered Wood Flooring ..........15mm
• Vinyl Tile & Siding ........................15mm
ADJUSTING THE BLADE
CUT GUIDE