STEP 3:
ANTENNA INSTALLATION
3.1
Once location has been determined fasten the antenna housing with the 4 self-tapping screws
to the vehicle frame.
3.2 Clean the bumper area with a degreasing solvent or detergent before applying the tape against
the antenna whip. Avoid bubbles under the tape to prevent moisture.
Install the antenna as vertically as
possible and away from metallic
objects (lights, radiator, gas tank
when installed at the back, etc.).
TAPE
NOTE: Avoid air gaps
in between tape and
bumper.
NOTE: The antenna performance depends on how vertical and how elevated the
antenna whip is from the road surface.
STEP 4:
CABLE ROUTING
4.1
Route the input cable through the engine compartment and firewall into the vehicle where the
radio is located.
4.2
Keep cables away from any moving parts.
4.3
Secure all cables with tie wraps in the engine compartment.
NOTE:
• Do not connect the input cable into the radio until the
tuning procedure (STEP 5) is complete.
• After routing attach loose connector (supplied with the antenna).
SINGLE ANTENNA CABLE ROUTING
VEHICLE FRAME
RADIO
INPUT CABLE
CABLE GOES THROUGH FIREWALL
TIE WRAP
ANTENNA
CONNECT TO VNA
(STEP 5)
