N O R M A
N O R M A
N O R M A
N O R M A
A U D I O E L E C T R O N I C S
A U D I O E L E C T R O N I C S
A U D I O E L E C T R O N I C S
A U D I O E L E C T R O N I C S
R E V O I P A - 7 0 B S a f e t y & U s e r M
A N U A L
p a g
. 8
88
8
1 - CONTROLS AND CONNECTION
Refer to the attached drawing in the last pages of the manual
1.1
LIST OF COMMANDS AND FRONT INDICATORS
Indicators of input selection
1 - Indicator IN 1
If the IN 1 input is selected [also by remote control] indicator is on.
2 - Indicator IN 2
If the IN 2 input is selected [also by remote control] indicator is on.
3 - Indicator IN 3
If the IN 3 input is selected [also by remote control] indicator is on.
4 - Indicator IN 4 [PHONO]
If the IN 4 input is selected [also by remote control] indicator is on.
Input IN 4 can be used as phono input through optional board.
Input IN 4 can be used as USB input through optional board.
5 - Indicator IN 5
If the IN 5 input is selected [also by remote control] indicator is on.
Only via IR the IN5 can be used as REC-OUT, in this way the selected input, with the exception of the direct
input DIR, can be send as an output to a recorder.
6 - DIRECT indicator [AV IN]
If the input DIR is selected [also by remote control] indicator is on.
This input is configured as a direct input to the final section. In this case the listening volume is not adjustable
by the volume control, but depends only on the level of the input signal.
7 - POWER indicator
If the unit is turned on, [even by remote control] indicator is illuminated at high intensity.
In STANDBY indicator is illuminated at low intensity.
In case of intervention of the protection circuits the indicator flashes at low intensity.
When the MUTE function is active the indicator flashes at high intensity.
8 - Multifunctional control SEL
Selection command used to power on the amplifier and for input selection.
9 - Infrared receiver for remote control [IR]
Optical receiving window for the infrared sensor of the remote control.
10 - Listening VOLUME control
Control speaker volume. Is also actuated by infrared remote control.
1.2 CONTROLS AND REAR CONNECTIONS
A - Mains Switch, Power ON / OFF.
Mains power switch. Housing for turn ON / OFF connection of the mains AC power.
B - Mains Socket Plug.
Mains power connector. Housing for connection of the network cable according to IEC / CEE 22. Check
that the mains voltage corresponds to that indicated on the label on the rear panel.
C - Fuse
AC mains fuse. Verify that the voltage, the type and value coincides with that indicated on the rear panel.
Attention!! For any reason the user must replace the fuse, it is a operation reserved for qualified personnel in
the service centers.
D - Heatsink
Device used for the dissipation of the heat generated by the amplifier.
During normal operation of the amplifier, and for a long time after it is turned off, the heatsink can be very
hot and therefore dangerous to touch. Never touch the heatsink during operation and for at least one hour
after shutdown.
U - GND: GND Phono
Ground socket for turntable in the case of use of internal phono stage [optional].
E - Speakers output [positive] left channel
Output jack of positive power.
F - Speakers output [negative] left channel
Output jack of negative power.