Norland Elite 437A150, Operator'S Manual

Page: 61 / 490

Operator's Guide
437D140 Rev. I
Installation and Setup 3-5
11. Plug in the Aladdin USB HASP key (that came with the software) into a USB port. Wait for the red light in the
HASP key to illuminate.
12. Installation of the software is now complete.
13. Remove the installation CD (if used) and store in a safe place.
The next few pages discuss some other set up instructions that should be completed before you actually log
into the Bone Density software:
"Configuring Backup for Windows 7" on the next page or "Configuring Backup for Windows 10" below to con-
figure the Windows Backup if the computer was not provided by Norland.
"Installing the Microphone" on the next page
See "Logging into the Illuminatus DXA Software" on page 3-11 when ready.
Configuring Backup for Windows 10
Computers provided by Norland with Windows 10 include the EaseUS Todo Backup program to automatically
perform a backup of the IlluminatusDXA software and data on a daily schedule. To configure the EaseUS
backup program on a computer not provided by Norland, follow the steps below. (The EaseUS program may be
used on any system running Windows XP or newer.)
1. Obtain the latest version of the EaseUS Todo Backup program from the vendor. Install the program with
default settings.
2. Insert a flash drive to be used for backup into an available USB port.
3. To allow the backup program to utilize the full capacity of the USB drive, drives should be formatted with an
NTFS filesystem.
4. Open the EaseUS Todo Backup program.
5. Select “File Backup”.
6. Deselect all default folders from the tree.
7. Under the Computer branch, check the box next to C:\IlluminatusDXA.
8. For the Destination Folder, browse to your USB flash drive.
9. Change the Plan Name to Norland Backup.