Restraint location
(6) per side
B
Drill Guide
C
Threaded Insert
D
Restraint location
(6) per side
Drill Guide
Hold flat against
outside bed
surface
T
Threaded Insert
U
Tighten until flange
is flush with bed
surface
1. Determine desired locations for Restraint Rings. Any
of the six locations on each side can be used.
2.
Drill Holes for Brackets
To drill the holes and install brackets, it is easiest if the
Bed is on its side. Place padding on the floor to
protect from scratches.
Wear protective gloves
when drilling holes, in case of
an accidental slip.
Place the Drill Guide on the Bed in the desired
location. The Drill Guide may be held by hand, or
clamped in place with a padded C-clamp if
necessary.
Hold the Drill Guide flat against the outside
surface as shown
.
It is important to drill the holes accurately in the
correct positions.
3. Using the provided 3/4" brad-point drill bit, drill
through the Bed. Drill carefully, and don't force the
bit. The Guide will help drill a hole that is
perpendicular
to the outer face of the Bed. High
speed on the drill is recommended.
If you must retract the drill bit to clear the chips,
ensure that you do not move the drill guide before
resuming so that you achieve a cleanly drilled hole.
Repeat drilling a hole in the other locations where
brackets will be installed.
4.
Install first threaded insert
Using a 6mm Hex Driver, install a threaded insert in the hole
adjacent to each bracket location. Tighten until the flange
is flush with the bed surface.
Do not overtighten.
Page 2 of 5
Rev. F - 1/12/21
091-991