17-6900-01
CONTACT INFORMATION
Congratulations on selecting Norfield Industries for your woodworking machinery solutions. A factory
Service Representative will be contacting you to review the site pre-installation requirements, and to
discuss the shipping schedule of your machine. Thereafter, our factory trained Field Engineer will
contact you to schedule the machine setup and training.
If you have questions regarding site preparations, or anticipate delays that will effect the installation,
please call the Norfield Service Department at 800-824-6242.
SITE PREPARATION BEFORE MACHINE ARRIVES
1 . Ve r i f y E l e c t r i c a l , A i r, a n d S p a c e R e q u i re m e n t s
Use the Table in the attached drawing (6815-001) to verify the Electrical and Air requirements.
A . ) Fo r E l e c t r i c a l R e q u i re m e n t s
1. For the 3-Phase power, E1, select your machine 3-Phase voltage con
fi
guration, either 208V/230V or
460V, and use the values in that row to verify the requirements.
2. The Single-Phase requirement is the same for both con
fi
gurations.
3. If new electrical power to the machine will be needed, only a quali
fi
ed electrician should complete
the installation. A 3-Phase circuit and a separate 230 volt Single-Phase circuit, including neutral
and earth ground is required.
Do Not
pull the 230 Single-Phase circuit from the 3-Phase circuit at the machine !
B . ) Fo r A i r R e q u i re m e n t s
1. If new air lines will be installed the pipe size can be no smaller than 3/8”. Pipe sizes will vary
depending on the length of the run. Check the table for the correct size.
2. Use the dimensions in the attached drawing (6815-001) to verify the space requirements for the
machine.
C . ) Fo r S p a c e R e q u i re m e n t s
1. Overall Length, 17ft. 1-1/2 inches, Width, including elevator motor, 48”, Height, 109” .
2. Clearance for service access, material
fl
ow (In & Out) should be considered when determining your
space requirements.
a. For Service Access, behind the machine, three (3ft) feet minimum, preferably four (4ft) feet.
b. For Material Flow (In & Out) minimum eight (8ft) feet.
3. If a standalone vacuum system will be used (not in-house system), use 3ft. x 5ft. dimensions for
determining space requirements.
1
Magnum Pre-install Guide 230V & 460V
