5. MAINTENANCE
INSTRUCTIONS
IMPORTANT
■
Always switch razor OFF
and remove plug from
outlet before cleaning.
■
Always store razor with
Protective Plastic Head
Guard on Razor Head
Assembly.
■
Never clean, remove or
replace head assembly
while motor is ON.
■
Do not apply pressure to
combs. Do not touch
razor heads with hard
objects as this may dent
or damage precision-
made slotted combs.
■
Do not use razor if combs
are damaged or broken.
5A. ONCE A WEEK
1. Clean Razor Head Assembly
as shown (Fig. 2).
2. Press Razor Head Release
Button and lift Razor Head
Assembly using thumb
and index finger to re-
move from razor housing
(Fig. 3).
3. Clean inside of Razor Head
Assembly and Hair Chamber
with long bristles of brush
(Fig. 4).
4. Press Razor Head Assembly
back on razor housing.
5B. ONCE EVERY 4-8
WEEKS
IMPORTANT:
Do
NOT
inter-
change the cutters and combs.
They are a matched set and if
interchanged may adversely
affect shaving performance
until cutters reseat them-
selves. Therefore, remove,
clean, and replace each set
individually.
1. Remove Razor Head Assem-
bly. Press Razor Head Re-
lease Button and lift Razor
Head Assembly using thumb
and index finger to remove
from razor housing (Fig. 5).
2. Squeeze S-formation in
center of retainer plate
and lift out from Razor
Head Assembly (Fig. 6).
3. Slide one cutter and comb
out of frame (Fig. 7).
4.
Each cutter and comb is a
matched set; do not inter-
change them.
Separate
one cutter/comb, at a
time, as shown (Fig. 8).
5. Cutter should be held as
shown and brushed in an
upward motion (Fig. 9).
6. Clean razor comb with
long bristles of brush in a
circular motion as shown
(Fig. 10).
7. For consistently close and
comfortable shaves, razor
heads should be cleaned
and lubricated every 4-8
weeks. After cleaning
heads in a degreasing liq-
uid (e.g. Norelco Razor
Cleaner, RAZORMATE
Electrosonic Cleaner or
alcohol), and reassem-
bling razor, spread Norelco
Razor Lubricant, model
AL80, or one drop of light
machine oil over floating
heads with your finger.
8. Replace cutter into comb
section, and slide back
into retainer plate.
9. Repeat procedure for
other cutting head.
10. Replace retainer plate,
with cutting heads in
place, back into Razor
Head Assembly. Press S-
formation until plate
clicks into place (Fig. 11).
11. Press Razor Head Assem-
bly back on razor housing.