Nordson Tribomatic 2, Customer Product Manual

Page: 28 / 73

Installation
3-2
E 1998 Nordson Corporation
All rights reserved
303 815A
Issued 3/98
Manual 37-32
3720021B
5
7
2
1
4
6
6
3
8
Fig. 3-1 Mounting the Tribomatic II automatic gun
1. Fixed gun stand or gun mover arm
2. Gun mounting bar assembly
3. Gun mounting bar 4. Adjuster
5. Ball mount flange
6. Set screws 7. Ball mount cap
8. M6 x 8 set screw
1. See Figure 3-2. Install the diffuser (1) into the charge module
body (2).
2. Install 6-mm blue air tubing (7) between the diffuser and the control
unit and 6-mm black flow-rate air tubing between the control unit and
the powder pump.
3. Connect powder feed hose (5) to the barbed diffuser fitting, route the
hose to the powder pump, and connect it the pump outlet connector.
Use snap clamps to secure the hose to the diffuser and pump
adapters. Wrap spiral-cut tubing around the hose where necessary to
prevent it from kinking and cutting off the flow of powder.
1. Mounting
(contd.)
2. Feed Hose, Air Tubing
and Ground Wire
Connections