Nordson Spectrum II S2-900 C Series, Installation, Operation And Maintenance Manual

Page: 41 / 262

Safety 2-1
2 Safety
2.1 Overview
This section is intended to provide basic safety information necessary for operating and servicing the
S2-900 Series Dispensing System. This section covers the following topics:
•
System Use
•
Laser Radiation
• Basic Safety Precautions and Practices • Emergency Shutdown
• Disposal • Interlock
•
Lifting and Transport Precautions
•
Service Shutdown
• Earthquake Precautions
•
Lockout/Tagout of Electrical and
Pneumatic Energy
• Safety Warning Labels
•
Residual Safety Risks
•
Light Beacon
To further optimize safe dispensing system operation, precautions and recommended practices are
included with the procedures throughout this manual.
WARNING! Unsafe equipment conditions can result in personal injury or property damage.
Failure to properly operate and maintain the system in accordance with this
manual could cause the built-in safety features to be ineffective.

NOTE Safety is considered a joint responsibility between the original equipment manufacturer
(Nordson ASYMTEK) and the end-user (owner). All safety precautions and practices
should be in accordance with local regulations and facility policy.
2.2 Facility Requirements
To ensure optimal performance and safety, it is necessary to install the dispensing system in a facility that
meets the necessary requirements. See
9.2 Facility Requirements
. If you have any questions, please
contact Nordson ASYMTEK Technical Support.
2.3 System Use
2.3.1 Intended Use
Use of Nordson ASYMTEK equipment in ways other than those described in the documentation supplied
with the equipment may result in injury to persons or damage to property.