Nordson Spectrum II S2-900 C Series, Installation, Operation And Maintenance Manual

Page: 123 / 262

Operation 4-51
4.12 Post Production Shutdown
To shut down at the end of a production shift:
1. Wait for the dispensing program to complete and verify that all motion has stopped.
2. Unload all workpieces.
3. Move the dispensing head to the front center of the system for easy access.
WARNING! Follow SDS recommendations for the proper handling, cleanup, and disposal of
all fluids used with the dispensing system .
4. Remove the valve, pump or jet and clean it as instructed in the appropriate valve manual.
5. Clean any spilled fluid from the dispensing system.
6. Shutdown the dispensing system. See
4.13 System Shutdown
.
4.13 System Shutdown
1. If applicable, perform a post-production shutdown. See
4.12 Post Production Shutdown
.
2. Exit Fluidmove.

NOTE
When Fluidmove closes, the machine will remain powered but the main air
solenoid will close and relieve all air pressure to the system.
3. Exit Windows.
4. Make sure Windows completely shuts down before turning off the computer.
5. Press the black
OFF
button on the S2-900 front panel to de-energize the system.
WARNING! Before performing any servicing or parts replacement, the system must be shut
down for service. Failure to do so could cause serious injury to the user and/or
serious damage to the dispensing system. See 2.13 Service Shutdown.