Nordson Encore XL Powder, Manual

Page: 45 / 155

© 2021 Nordson Corporation
1607027-01
4-3 Setup
Changing Function Values
Swing down the control panel door to access the PLC.
NOTE: These instructions are also reproduced on a label on the inside the control panel
door.
Figure 4-1 Feed Center PLC Interface
1. Press the ESC key to begin search mode.
2. Find the function screen to be changed by pressing the UP (.._) or DOWN (T) arrow
keys.
3. While on the selected screen, press and hold the ESC key. A cursor will appear.
4. Use the LEFT (◄) and RIGHT (►) arrow keys to position the cursor on the value to
be changed.
5. Press the OK key to highlight the value.
6. Use the LEFT (◄) and RIGHT (►) arrow keys to select the correct units (xx:xx)
column, and then the UP (.._) and DOWN (T) arrow keys to change the value.
7. Press the the OK key to enter the value.
8. Make additional changes to the same page by moving the cursor as described in
steps 4−7.
9. When data changes to the page are complete, press the ESC key twice.