Nordson Encore HD iControl 2, Installation, Troubleshooting, Repair

Page: 40 / 114

© 2022 Nordson Corporation
1609758-04
3-16 Installation
Scanner Cable Connections
See Figure 3-8. The PEJB and scanner junction boxes are shipped with the scanner
cables pre-wired to the junction boxes. The scanner controllers are programmed at the
factory according to the system order specifications.
Refer to the system plan views when locating the part ID stand and scanners or
photoeyes. The scanners must be mounted with the cable ends oriented as shown.
Discrete Scanner Connections
• Single-Zone Scanner: SCNR1 cables to scanner.
• Dual-Zone Scanners: SCNR1 cables to upper scanner, SCNR2 cables to lower
scanner.
• Part ID Scanner and Zone Scanner: SCNR1 cables to zone scanner, SCNR2 cables to
part ID scanner.
NOTE: The part ID scanner or photoeyes must be located so that the iControl 2 system
receives the part ID before the leading edge of the part breaks the zone scanners or
photoeyes.
PEJB
PD1
PEJB
PD1
SCNR1
SCNR2
PEJB
PD1
SCNR1
Single-Zone Scanner Dual-Zone Scanner
Part ID Scanner
Zone Scanner
Part Travel
Part ID and Zone Scanners
Figure 3-8 Zone and Part ID Scanner Cable Connections (Typical)