The Odin 2 Power Cord is the most
critical cable in your loom. It will
ensure the optimum transfer of AC
power, free from the harmful effects
of electromagnetic interference
and radio frequencies, needed to
seamlessly run your sound system.
Please ensure that the IEC end
of the power cord is fitted firmly
into the IEC receptacle. Then plug
the power connector into the wall
socket, or into the your QRT power
product. When placing or changing
out Odin 2 Power Cords, please
Odin 2 Interconnects are terminated
with color-coded RCA and XLR
connectors. The connector that
shows “HOLO:PLUG” engraved in
black should be connected to the
black connection (left channel) on
the rear of your component. The
connector that shows “HOLO:PLUG”
engraved in white should be
connected to the red connection
POWER CORDS
INTERCONNECTS
LOUDSPEAKER / BI-WIRE JUMPER CABLES
Odin 2 Loudspeaker Cables are
terminated with Nordost’s own
gold-plated HOLO:PLUG® spade
and low-mass Z plug Banana
connectors. When installing Odin
2 Loudspeaker Cables into your
system, do as follows: Attach the
connector wrapped in black (–)
to the black terminal on both the
power amplifier and loudspeaker.
Attach the connector wrapped in
white (+) to the red terminal on the
power amplifier and loudspeaker.
All Nordost cables are directional.
To ensure the highest quality
sound, the wooden blocks marked
with directional arrows must point
towards the loudspeaker.
Odin 2 Loudspeaker Cables are only
available in shotgun configuration.
be aware that the HOLO:PLUG®
connectors used on all of our power
cords are capable of marking the
surface of equipment or furniture
if dropped, so careful handling is
recommended.
An increasing amount of hifi audio
components require the use of
IEC C-19 input connectors. For
this reason Nordost provides this
upgraded option in both our Odin
2 Power Cords and our QB8-Mark II
power distribution units.
(right channel) on the rear of your
component. All Nordost cables are
directional. To ensure the highest
quality sound, the directional
arrows shown on the wooden
blocks should point in the direction
of the signal. Example: On the
interconnect placed between a CD
player and an amplifier, the arrows
should point towards the amplifier.
It is important to note cable
geometry of Odin 2 RCA and
XLR Interconnects is specifically
constructed for each termination.
Due to the distinct design difference
between these two cables, re-
termination from one variety to the
other is not available.
If you should have equipment that
requires either bi-wire or bi-amp
connections, invest in the Odin 2 Bi-
Wire Jumper. Odin 2 Bi-Wire Jumpers
are an exact extension of Nordost’s
Supreme Reference Loudspeaker
Cables, ensuring a consistent sonic
signature throughout your system.
ARROWS POINT IN
DIRECTION OF SIGNAL
ARROWS POINT IN DIRECTION OF SIGNAL
Summary of Contents for ODIN 2
Page 1: ...INSTRUCTION MANUAL...
Page 6: ......
