Causes of damage
Caution!
Installation
Fitted units
90
o
C.
Note: There should be gap above the oven.
Installation dimensions
min 45
Cupboard feet
Ventilation grid
min 45
50
460
250
5
■
Operating the microwave without food: Operating the appliance without food in the cooking compartment may lead to overloading.
Never switch on the appliance unless there is food in the cooking compartment. An exception to this rule is a short crockery test
(see the section "Microwave, suitable crockery").
■
Using the appliance door for standing on or placing objecs on: Do not stand or place anything on the open appliance door. Do not
place ovenware or accessories on the appliance door.
■
Transporting the appliance: Do not carry or hold the appliance by the door handle. The door handle cannot support the weight of
the appliance and could break.
■
Microwave popcorn: Never set the microwave power too high. Use a power setting no higher than 600 watts. Always place the
popcorn bag on a glass plate. The disc may jump if overloaded.
■
Liquid that has boiled over must not be allowed to run through the turntable drive into the interior of the appliance. Monitor the
cooking process. Choose a shorter cooking time initially, and increase the cooking time as required.
■
The oven should be cleaned regularly and any food deposits removed since they may explode, even after microwave heating has
ended.
■
Failure to maintain the oven in a clean condition could lead to deterioration of the surface that could adversely affect the life of the
appliance and possibly result in a hazardous situation.
■
Ventilation slots and intakes must not be covered.
■
The safe operation of this appliance can only be guaranteed
if it has been installed in accordance with these installation
instructions.
■
The fitter is liable for any damage resulting from incorrect
installation.
■
The units into which the appliance is fitted must be heat-
resistant up
■
This appliance is only intended to be fully fitted in a kitchen.
■
This appliance is not designed to be used as a tabletop appliance
or inside a cupboard.
■
The fitted cabinet must not have a back wall behind the appliance.
■
A gap of at least 45 mm must be maintained between the wall and
the base or back panel of the unit above.
■
The fitted cabinet must have a ventilation opening of 250cm on
the front. To achieve this, cut back the base panel or fit a
ventilation grille.
Summary of Contents for NM525IX
Page 24: ......
