NORDline RD250L, Instruction Booklet

Page: 15 / 40

EN - 13 -
Fixing the appliance to the wall
Note: This fixing part should be used for in the case of , the appliance is out off balance
when then the inside of the appliance is fully empty but the door shelves are full
with stuffs.
For usage please follow the below instructions
1- Check the kit to locate the following parts.
Part No Description Quantity Used
4 Screw M4 No:4 2 pcs For fixing Bracket (Part no: 2) to the appliance
3
Screw f or plastic
No:3 (Ø 3,5mm)
2 pcs For fixing Bracket (Part no: 2) to the w all
2 Fixing Bracket 2 pcs Main part f or f ixing
1 Screw grommet 2 pcs For fixing Plastic screw (Part no: 3) to the w all
2- Prepare a star-tip screwdriver for fixing the screws.
3- Prepare a driller for making hole to the wall.
4- Put the refrigerator, where you will use it.
5- Refer the holes, which has been drilled before on the top of the refrigerator, and
mark the hole places on the wall.
6- Drill the holes on the wall with Ř 8 mm.
7- Put screw grommet (Part no: 1) in to the hole.
8- Assemble the fixing part (no: 2) to the wall by using the plastic screw (part no:3)
9- W ith the screw M4 (Part no: 4) assemble the fixing bracket to the refrigerator.
10- If your appliance is Tropical class then fix Screw M4 to the “T” hole on the bracket;
if your appliance is Normal class the fix Screw M4 to the “N” hole on the bracket.
11- Do the same actions to the 2
nd
fixing part.
T
4
3
2 1
N F
T
N
F
HOLE
Figure -1 Figure -2