7
2. Identify the Left Upright (73) and the Right
Upright (74).
Have a second person hold the Right Upright
(74) near the Right Base Cover (77).
See the
inset drawing.
Make sure the long tie extends
from the rectangular hole in the Right Upright.
Tie the long tie securely around the end of the
Wire Harness (75). Then, pull the other end of
the long tie until the Wire Harness is routed com-
pletely through the Right Upright.
Gently pull up on the Wire Harness (75) as you
set the Right Upright (74) on the Base (83) in-
side the Right Base Cover (77).
Be careful not
to pinch the Wire Harness.
Partially attach the Right Upright (74) to the
Base (83) with two 3/8" x 3 3/4" Bolts (53) and
two 3/8" Star Washers (90).
Do not fully tighten
the Bolts yet.
Note: It may be necessary to tip
the tops of the Uprights forward slightly as you
thread the Bolts into the Uprights.
Attach the Left Upright (73) to the Base (83) with
two 3/8" x 3 3/4" Bolts and two 3/8" Star
Washers (not shown).
Do not fully tighten the
Bolts yet.
With the help of a second person, lower the
treadmill off the cardboard stand. Save the card-
board stand for step 8.
83
75
Long
Tie
77
2
74
73
90
53
3. Identify the Right Upright Sleeve (96) and the
Left Upright Sleeve (95); the Upright Sleeves are
labeled “Left” and “Right.” Slide the Right Upright
Sleeve onto the Right Upright (74) and the Left
Upright Sleeve onto the Left Upright (73).
95
“Right”
“Left”
96
3
74
73
75
74
Long Tie
