4
Place all parts of the ski exerciser in a cleared area and remove the packing materials; do not dispose of the
packing materials until assembly is completed. Assembly requires only the included flat wrench tool.
A
SSEMBLY
1
3
73
72
2
Hole
1
2
74
92
Stud
Slots
94
93
76
2
76
1. Attach the Leg Bracket (2) to the Front Frame (1) with
two M10 x 16mm Hex Screws (73) and two M10
Washers (72) as shown. Make sure that the ends of the
Leg Bracket angle away from the Front Frame and that
the indicated hole is in the position shown.
2. Insert a Leg (76) up into the square opening in either
end of the Leg Bracket (2). Align the second hole from
the bottom of the Leg with the hole in the Leg Bracket,
and insert the straight end of a Leg Pin (74) into the
holes. Make sure that the Leg Pin goes completely
through the holes and that the bent end of the Leg
Pin points toward the floor. Rotate the Leg Pin to
secure it around the Leg.
Slide an Incline Clamp (92) onto the indicated stud and
into the slots in the Leg Bracket (2). Tighten an Incline
Knob (93) with an Incline Washer (94) onto the stud.
Attach the other Leg (76) in the same way.
3. Lift the Upper Body Arm (27) slightly so it will not catch
on the Front Frame (1), and raise the Upright (16) to the
position shown. The Upright will snap into place when it
is positioned correctly. Make sure that the M8 Push Nut
(18) is between the Upright and the Front Frame.
Tighten the two Upright Knobs (17). Note: Each Upright
Knob functions like a wrench. Turn the Upright Knob
clockwise, pull it away from the Upright (16), turn it
counterclockwise, push it toward the Upright, and then
turn it clockwise again. Repeat this procedure until the
Upright Knob is tight.
27
16
17
17
1
18
