11
9
10
Avoid pinching
the wires
7
10. Untie and discard the wire tie on the Upper
Wire (110).
While a second person holds the Console (7)
near the Upright (4), plug the Upper Wire (110)
and the Pulse Wire (63) into the receptacles on
the Console.
The connectors on the Wires (110, 63) should
slide easily into the receptacles and snap
into place. If a connector does not slide eas-
ily into a receptacle, turn the connector and try
again. If you do not connect the connectors
properly, the Console (7) may become dam-
aged when you use the elliptical.
Insert the excess wire into the Upright (4) or into
the Console (7).
Tip: Avoid pinching the wires. Attach
the Console (7) to the Upright (4) with four
M4 x 16mm Screws (101); start all the Screws,
and then tighten them.
101
82
82
129
129
60
64 Grease
58
4
110
63
101
9. Apply grease to one of the Pedal Arm Axles (64).
Next, slide an M8 x 21mm Washer (129) onto an
M8 x 12mm Screw (82), and tighten the Screw a
few turns into the Pedal Arm Axle (64).
While a second person holds the front end of the
Right Pedal Arm (58) inside the bracket on the
Right Upper Body Leg (60), insert the Pedal Arm
Axle (64) into both parts.
Next, slide an M8 x 21mm Washer (129) onto
another M8 x 12mm Screw (82), and tighten the
Screw a few turns into the Pedal Arm Axle (64).
Then, tighten both Screws at the same time.
Repeat this step on the other side of the
elliptical.
