8
6. Cut the tie securing the wires to the Uprights (85). Have a
second person hold the console assembly near the
Uprights. Connect the Upright Wire Harness (73) and the
Pulse Wire (74) to the wires extending from the console as-
sembly.
The connectors should slide together easily
and snap into place. If they do not, turn one connector
and try again.
Insert the connectors into the console as-
sembly. If necessary, remove the right accessory tray (not
shown) from the console assembly.
Connect the Upright Ground Wire (113) to the ground wire
extending from the console assembly. Make sure that the
wires are fully inserted into each other. Insert the ground
wires into the console assembly. Reinsert the right acces-
sory tray (not shown) into the console assembly if neces-
sary.
85
73
Console
Assembly
Ground
Wire
74
113
6
73
74
5. Cut the tie securing the Pulse Wire (74) to the Uprights
(85). Hold the Pulse Bar Assembly (69) near the crossbar
on the Uprights. Connect the Pulse Wire to the wire in the
Pulse Bar Assembly.
The connectors should slide to-
gether easily and snap into place. If they do not, turn
one connector and try again.
Insert the wires into the
crossbar.
Open parts bag B.
Attach the Pulse Bar Assembly (69) to
the crossbar on the Uprights (85) with four Pulse Bar Bolts
(127) and Star Washers (67). Start all four Pulse Bar Bolts
before tightening them.
Make sure that no wires are
pinched.
85
74
127
127
69
67
5
67
74
7. Set the console assembly on the Uprights (85).
Make sure
that no wires are pinched. Finger tighten
a Console Bolt
(72) with a Star Washer (67) into the lower hole in each
Upright (only one side is shown).
Next,
finger tighten
a Short Console Bolt (112) with a
Star Washer (67) into the upper hole in each Upright (85)
(only one side is shown).
Be careful not to drop the
Short Console Bolts into the Uprights.
Firmly tighten
the two Console Bolts (72) and the two Short Console
Bolts.
Insert an Upright Endcap (71) into the top of each Upright
(85) (only one side is shown). Note: Insert the end of the
Upright Endcap indicated by the arrow first; use a rubber
mallet if necessary.
112
85
67
67
72
7
Console
Assembly
71