11
11. With the help of a second person, carefully
lower the Uprights (85) to the position shown.
Attach the Right Base Cover (86) with three #8 x
3/4" Screws (7) and two #8 x 2 1/4" Screws (63).
Start all five Screws before tightening any of
them. Be careful not to overtighten the
Screws. Attach the Left Base Cover (88) in
the same way.
With the help of a second person, carefully raise
the Uprights (85) to the vertical position.
13.
Make sure that all parts are properly tightened before you use the treadmill.
If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used
to adjust the walking belt (see pages 30 and 31).
63
7
88
86
63
7
85
11
12. Note the location of the 75 ohm terminal on the
treadmill. For the television to operate, an RCA
component video cable must be connected to
the audio/video input jack on the back of the con-
sole or a CATV cable or an antenna must be
connected to the 75 ohm terminal (see page 13).
12
75 Ohm
Terminal
10.
See drawing 10a.
Remove the indicated #8 x
3/4" Screw (7) from the right Handrail (70).
See drawing 10b.
Slide the Right Upright
Sleeve (9) up to the console assembly. Attach
the Right Upright Sleeve with two #8 x 1" Tek
Screws (82) and with the #8 x 3/4" Screw (7)
that you just removed.
Attach the Left Upright Sleeve (not shown) in
the same way.
9
7
7
70
82
Console
Assembly
10a
10b