5. Insert two Handrail Bolts (78) with 5/16” Star Washers
(77) into the right Upright (69) and the right Handrail (66).
Be careful not to damage the Upright Wire Harness
(not shown).
Next, lift the right Handrail slightly and align
the Handrail Bolts with the holes in the Handrail. (Note: If
necessary, twist the Handrail to align the holes in the
Handrail with the Bolts). Thread the Bolts into the
Handrail.
Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Then,
tighten all four Handrail Bolts (78).
Note: There
are no wire harnesses on the left side.
7.
Make sure that all parts are properly tightened before
you use the treadmill.
Keep the included allen wrench
in a secure place. The allen wrench is used to adjust the
walking belt (see page 28).
To protect the floor or car-
pet from damage, place a mat under the treadmill.
5
78
69
77
4. Insert a Handrail (66) into each side of the console as-
sembly. Note: It may be helpful to twist each Handrail as
you insert it.
Cut the tie securing the Upright Wire Harness (98). Have a
second person hold the console assembly near the
Uprights (69). Connect the Upright Wire Harness to the
wire harness extending from the Console Base (81).
The
connectors should slide together easily and snap into
place. If they do not, turn one connector and try again.
Insert the connectors and the Upright Wire Harness down
into the right Upright, and then set the console assembly
on the Uprights.
Be careful not to pinch the wires.
98
69
66
81
4
66
6. Attach the Upper Handrail (123) to the Uprights (69)
with two 3” Bolts (119) and two Handrail Washers (120)
as shown. Firmly tighten the Bolts.
6
119
120
123
69
119
7
Console Assembly
