INSERTO 60 – 70 – 70 To – 70 Pr – 70 H49
22
6090710 – EN
•
The air intake must be positioned so that it cannot be obstructed.
•
Be communicating with the installation room of the appliance and be protected by grating.
•
Minimum surface must not be lower than 113 cm
2
.
•
Should the inflow of air be obtained by openings communicating with outside of nearby rooms, it is
necessary to avoid air intakes in connection with garages, kitchens, bathrooms, thermal units (see
Picture 14
).
9.
CONNECTION AND MAINTENANCE OF VENTILATION
The control unit and the plant must be installed and connected by authorized personnel according to the
standards in force. (see chapter.1)
ATTENTION: the feeding cable must not be in contact with hot parts.
Our inserts are equipped with tangential fans suitable to improve the distribution of heat through the ventilation
exclusively of the installation room (see chapter.6).
The lighting and the adjustment is carried out through the proper standard supplied control unit that has to be installed
far from any direct heat source. The kit is equipped with a thermostat
(TM)
that lets the fans start when the appliance
is properly heated, and stops them when it is partially cold.
If the control is switched on (pos.
I
halfway speed – pos.
II
maximum speed), the ventilators work when a pre-set
temperature is achieved.
Picture 14
Picture 15
Picture 16
(2) Seal
(3) Insulating coating with external
aluminum sheet
(4) Door for cleaning
(5) External air intake
(1) Insulating material
(6) Heat drain grating
(7) Fire-retardant counter-hood
(9) Shield wooden parts with
insulating material
ACCORDING TO
THE REGIONAL REGULATIONS
(10) Min. distance between Coating and
INSERT
see MARKING INFORMATION
(8) Maximum inclination 45°
MANDATORY
: cable
out of seeing!
L
Ph
N
E
E
M M
Marrone
Blu
Giallo / Verde
M
M
TM
Marrone
Blu
Giallo / Verde
B
lu
2
0
m
m
230 V~ – 50Hz
