10
NORDIC
• Hold front handle with one hand and auxiliary handle with the other hand.
• Make sure that cutting line is fed out before operation.
• Do not switch the machine on with the cutting head on or near material
to be cut. Ensure the machine is at full speed before contacting material
to be cut.
• Keep unit below waist level.
• Work only from your right to your left to ensure debris is thrown away
from you. Proceed slowly, keeping the trimmer inclined (approx. 30°)
• Without bending over, keep cutting head near and parallel to the ground
(perpendicular when edging). Allow only the tip of cutting line to make
contact.
• Do not cut damp or wet grass.
• High grass should be cut in layers, always beginning from the top. The
cuts should be short.
• Avoid wearing the cutting line out quickly by knocking against hard
objects (stone, walls, fences etc).
• Avoid swinging over the extension cord with the device still running. You
could damage it. You should always play out the extension cord behind
yourself.
• To edge, rotate the upper shaft with front handle 180°, place the edger
wheel and cutting head above the surface you are going to edge.
REPLACING THE TRIMMER SPOOL
WARNING! Use only cutting lines with correct diameter. Other sizes of cutting line will not feed properly
and will result in improper function or can cause serious injury.
FITTING TRIMMER SPOOL
AND CUTTING LINE COMPLETE
Your trimmer is supplied with a fully disposable trimmer
spool which overcomes troublesome rewinding the
cutting line.
1. Remove the battery pack.
2. Clean any grass or debris from the trimmer head.
3. Press and hold in the cover release latches to open
the cutting head cover and pull out the old trimmer
spool from the cutting head. (see picture)
