NORDIC PLAY 805-762, Manual, Page: 4 / 60

Loosen the screw from the back of the seat seat, take away the seat. Then connect the battery line red wire
to the red terminal of the battery and finally then connect black wire to black battery terminal. Never connect wires
into the uncorrect battery terminals. After the connections, please assemble the seat back to the original place and
tighten the screw.
Battery replacement and fuse
The battery is equipped with a thermal fuse which blows if the motor, battery or electrical circuit is overloaded. The
vehicle must then be switched off for at least 5 minutes, after which the fuse will restore itself. If the product does not
work, the fuse may therefore be the problem. To avoid this, read the following points:
• Do not overload the vehicle.
• Do not pull anything behind the vehicle.
• Do not drive up steep hills.
• Do not run into motionless objects that cause the wheels to spin.
• Do not drive at extreme temperatures.
• Make sure the product does not come into contact with liquids.
• Do not touch the electrical circuit.
As the battery gets older it will start to lose some of its capacity. Depending on the conditions, it can last anywhere
from 1 - 3 years. If the battery needs a replacement, follow these steps:
1. Loosen the crew and remove the seat.
2. Disconnect the cables from the battery terminals.
3. Remove the battery cover.
4. Carefully lift the battery out of the vehicle. Depending on the condition of the battery (leakage or similar), safety
equipment may be required. Do not lift the battery from its wires but from the battery itself.
5. Put the battery in a plastic bag and dispose it responsibly. NEVER put the battery to general waste.
6. Insert the new battery into the vehicle.
7. Reconnect the cables to the new battery. Red wire to red terminal (+) and black wire to black terminal (-) of the
battery.
8. Slide the seat into place. Tighten the screw.
GB
IMPORTANT NOTE : When shifting (forward/backward), please make sure the vehicle is completely stopped,
otherwise it will damage the gear box and motor.
Forward: 1. Press the ”Forward/backward switch” to the ”Forward” position.
2. Press the ”Foot pedal”, the vehicle drives forward.
Stop:
1. The vehicle will brake automatically, when foot is lifted from the ”foot-pedal”.
Back Up: 1. Press the ”Forward/backward switch” to the ”Backward” position.
2. Press the ”Foot pedal”, the vehicle will back up.
1. Insert 220V/12V charger cable’s connector to the vehicle.
2. Insert actual 220V/12V charger unit to your 220V power outlet. The battery will start charging.
3. Detach after 8-12 hours