NORDIC LEGEND B33Z08, Care And Use Manual, Page: 8 / 20

CARE AND USE MANUAL
MODEL B33Z08 & B33Z10
POWER ICE AUGER
TOLL FREE HELP LINE 1-844-688-0690 8
OPERATION: COLD STARTS
STARTING AND STOPPING ENGINE AT 32ºF AND BELOW
•
Move engine to a well ventilated area, outdoors, to prevent carbon monoxide poisoning.
•
Move to an area away from flames or sparks to avoid ignition of vapors if present.
•
Remove all debris from air cleaner holes and gas cap to ensure proper airflow
Cold Engine Start
1. Move choke lever to RUN
Note: Choke must be in the RUN position when pushing or using the primer bulb
2. Prime unit until primer tube is filled with fuel
Note: When using the primer bulb allow the bulb to return completely to its original position between pumps
3. Hold the Red COLD START lever toward the arrow, and press the primer bulb three more times.
4. Move Choke lever to CHOKE position
Note: Choke position is defined as moving the Choke lever as far to the ON position as possible
5. Push toggle switch to the ON position
6. Slowly pull RECOIL rope out in about 4”(10CM), and then pull briskly to turn over the engine.
7. After engine starts running, move Choke lever to HALF-CHOKE position until unit runs smoothly
Note: HALF-CHOKE is defined as when the Choke lever is half-way between Choke and Run
8. Once the engine is running smoothly, move the Choke lever to the RUN position and move throttle to the desired speed
Note: Run at full throttle whenever possible and do not let unit idle for extended periods of time
9. If the engine does not start in 5 pulls, wait 5 minutes and repeat the process from No.6.
10. To stop engine, push the toggle switch to the OFF position
Warm Engine Start
1. Move the Choke lever to the Choke position
Note: Choke position is defined by moving the choke lever as far to the ON position as possible
2. Continue to Step 5 of the Cold Engine Starting procedure
Hot Engine Start
1. When weather is very hot, begin with Step 5 of the Cold Engine Starting procedure
2. If engine does not fire (Run), refer to Step 1 of the Warm Engine Starting procedure
NOTE: NEVER ATTEMPT TO START ENGINE IN ANY OF THE FOLLOWING WAYS
•
DO NOT USE A STARTING FLUID
•
DO NOT SPRAY FLAMMABLE LIQUIDS OR VAPORS INTO AIR CLEANER, CARBURETOR OR SPARK PLUG CHAMBER
•
DO NOT REMOVE SPARK PLUG AND PULL ON STARTER ROPE. FLAMMABLE FUEL CAN SPRAY OUT AND IGNITE FROM A
SPARK FROM THE SPARK PLUG