NordicCab
Instructions and user manual for the NordicCab Explorer
Page 15 of 25
MOUNTING THE SEAT
1
2
3
4
Attach the support block under
the seat. The block is fastened
with Velcro to the plate under
the seat base.
Stand in front of the casing.
Place the base of the seat to
the rear edge of the casing.
Insert the plastic brackets in
the grooves on the aluminium
rails, and lock the seat in the
desired position.
Lift up the springs on the left
and the right side of the seat
base to move the seat to
another position.
Straps for attaching the
seatback.
Take the upper
straps on the seatback and
bring them over the top tube of
the rear roll bar. Then bring
the lower straps on the
seatback under the bottom
tube of the roll bar. Fasten the
buckles. Pull straps until the
seatback is tightly secured.
Adjusting the seatback:
Rest position – adjust the
straps to the desired position.
The base of the seat must also
be pushed to the desired
position)
Recumbent – Three straps
around only the bottom
tube.
WARNING
The seat must always be in the upright position when the cart is used as a bicycle trailer or when used
with speeds over normal walking speed (4 km/h). This is because in the case of accident, the seatback
provides best protection in the upright position.
WARNING
Remember to fasten the seat correctly and tighten the straps securely. This gives the child the best
safety and protection.
WARNING
Always ensure that the base of the seat is securely locked in one of the three possible positions.