nord NORDAC START Series, User Manual

Page: 54 / 120

NORDAC START (SK 135E / SK 175E) – Users Manual for Motor Starters
54 BU 0135 en-4118
3 Display, operation and options
WARNING
Electric shock
When devices are open, electrically conducting elements (e.g. connection terminals, connection cables, PCBs,
etc.) are freely accessible. These may be live, even if the device has been switched off.
• Avoid all contact.
The device can be basically started up without parameter adaptation, i.e. programming-technical aids.
4 potentiometers (P1 – P4) and a 4-pin DIP switch block (S1) are available for this. Access to P1 and
P2 takes place using the diagnostics opening in the centre. This is where the status LEDs of the
device are located. Potentiometers P3 and P4 and the PROFIBUS DP addressing (SK 175E-…-PBR
only) are accessible by removing the cover of the device.
The SK 1x5E can be easily adapted to a wide range of requirements by using function-enhancing
modules for display, control and parametrisation.
Optionally available control devices from NORD or the free "NORDCON" PC software can be used for
targeted adaptation of individual parameters. The right-hand diagnostic connection must be opened to
access the diagnostic interface. Devices with an older manufacturing date (serial number (ID) "
26P…
"
or less) only have the diagnostic opening in the centre. The diagnostics interface is then only
accessible by removing the cover of the device.
3.1 Control and parametrisation options
Various control options are available that can be fitted directly to the device or in close proximity to it
and directly connected.
Parametrisation units also provide a facility for accessing the parametrisation of the device and
adapting it.
Designation Part Number Document
Switch
(attachment)
SK TIE4-SWT Switch "L-OFF-R" 275274701 TI 275274701
Control and parametrisation units /(handheld)
SK CSX-3H
SimpleBox
275281013 BU0040
SK PAR-3H ParameterBox 275281014 BU0040
PROFIBUS DP addressing
(SK 175E-…-PBR only)
Status LED for bus system
(SK 175E only)
Potentiometer P1
Potentiometer P2
Device status LED (DS)
Diagnostic interface RJ12
(RS232)
Potentiometer P3
Potentiometer P4
Diagnostics openings