w w w . h a w k e y e e l e c t r o n i c s . c o m
P ARTS SU PPLIE D IN P ACK AGIN G:
The Following Parts should be included in your H22PX
Packaging:
•
H22PX Handheld Sonar System
•
Battery Cap
•
Battery Holder (inside the battery compartment)
•
Lanyard (attached to the Battery Cap)
•
FreedomClub Card
•
User’s Guide
If any items are missing or damaged, please contact our
customer service department.
INST ALLI N G THE B ATT E RIES :
1. Open the battery cap by unscrewing the battery cap counter-
clockwise.
2. Remove the battery holder and install four ‘AA’ batteries. Be
certain to align the batteries as per the diagram inside the
battery compartment.
3. Align the channels on the battery holder with the grooves
inside the electronics housing.
4. Insert the battery holder into the electronics housing,
terminal side down, and turn the cap clockwise until snug (do
not over-tighten).
I
MPORTANT
:
To ensure the device remains water tight, coat
the Battery Cover O-Ring with silicon grease
(available at any dive shop) each time you
replace the batteries.
W
ARNING
:
Never mix different brands of batteries. Never mix new and used
batteries (alkaline, lithium, argon zinc, & rechargeable). Never use
damaged batteries. REMOVE BATTERIES DURING STORAGE.
REMOVE DEAD BATTERIES IMMEDIATELY.
N
OTICE
:
If you are going to be using the H22PX in temperatures below 20º F (-7 ºC)
you must use Lithium ‘AA’ batteries. Cold temperatures significantly reduce
the power output of Alkaline batteries, which will inhibit the performance of
the device.
Sonar
Sensor
Battery
Cap
Activation
Switch
