w w w . h a w k e y e e l e c t r o n i c s . c o m
4. The bracket is designed for a standard 13° transom
angle. To determine if the plastic shim is needed,
position the transducer at the desired location.
Using a straight edge, compare the underside of the
transducer relative to the underside of the hull. The
stern (trailing edge) of the transducer should be
1/16" - 1/8" (1 - 3 mm) below the bow (leading edge)
of the sensor.
5.
Apply a marine sealant to the threads of the two #10
x 1-1/4" self-tapping screws and screw the bracket
to the hull. DO NOT tighten the screws completely
until you position the transducer as per # 4 above.
N
OTICE
Do not allow the leading edge of the
transducer to extend more than 1/8"(3 mm)
of an inch below the bottom of the boat as
this will create increased aeration and
turbulence.
N
OTICE
:
Align the included shims to achieve a slight angle as per the illustration
below. To prevent aeration, NEVER position the transducer in a
manner that the Leading Edge
(bow)
is LOWER than the Trailing Edge
(stern).
